Engineering Practices Lab - Electronics

 

S.No.	Experiment	Identification
1.	Verify the logical multiplication, addition and Negation using truth table experimentally	Multiplication -AND Addition- OR Negation -NOT
2.	Construct a circuit to convert an a.c signal to a pulsating dc signal during the positive half cycle of the input and calculate the necessary parameter experimentally (OR) Design a rectifier using one diode and measure the ripple factor without filter	Half wave rectifier
3.	Construct a circuit to convert an ac signal to a pulsating dc signal during both positive and negative half cycles of the input and calculate the Ripple factor experimentally. (OR) Design a rectifier using two diode and measure the ripple factor without filter	Full wave rectifier
4.	Find the resistance value of the given resistors (4 numbers) using colour code.	Resistance Colour code
5.	Generate the clock signal and measure its parameters using CRO. Plot the waveform.	Clock signal
6.	verify the connectivity of the circuit using multimeter and disassemble the components from the board.	Soldering